AskGene.com

If it happened, most likely the problem is a bad water inlet valve.  Unplug the power cord. To get access to the part, you have to remove the cabinet (read “How to remove the cabinet on Whirlpool or Kenmore direct drive washer”). The water inlet valve is mounted to the rear panel on the right […]

If your Whirlpool or Kenmore direct drive washer does not spin or agitate but does drain, most likely the problem is a worn out motor drive coupling. Unplug the washer or disconnect power. To replace the motor drive coupling you have to remove the cabinet (read post “How to remove the cabinet on Whirlpool or Kenmore direct drive […]

The most common cause of water leaks on the Whirlpool or Kenmore (with 110 prefix in the model number) direct drive washer is the water pump. After you remove the cabinet (read the post “How to remove the cabinet on Whirlpool or Kenmore direct drive washer”) at the bottom of the washer, in front (in the right […]

In order to get access to any part on your Whirlpool or Kenmore (with 110 prefix in the model number) direct drive washer (direct drive means “no belts”) the first thing you have to do is remove the cabinet. In this article, I’ll explain how to do that. 1. UNPLUG THE WASHER 2. Using a Phillips screwdriver, […]