AskGene.com

The error code “F2” will be displayed along with a beeping sound if the ERC (Electronic Range Control) or “clock” senses a runaway heat condition during the “cook” or the “clean” modes. It could be caused by the oven temperature sensor, by the ERC or by the wire harness between the oven temperature sensor and […]

The error code “F4” will be displayed along with a beeping sound if the ERC (Electronic Range Control) or “clock” determines an open oven temperature sensor circuit during the “cook” (bake or broil) mode. The “F4” message will not be displayed in the time of day mode. The cause of the problem is a bad oven […]

Most likely the problem is a clogged up vent outside the dryer. Before you take any action, disconnect the vent hose from the back of the dryer and run a regular load with the hose disconnected. If the clothes are dry at the end of the cycle, no doubt the problem is a clogged up […]

If it happened, most likely the problem is a bad water inlet valve.  Unplug the power cord. To get access to the part, you have to remove the cabinet (read “How to remove the cabinet on Whirlpool or Kenmore direct drive washer”). The water inlet valve is mounted to the rear panel on the right […]

The most common and the most dangerous cause of the flooding in the laundry room is a broken water fill hose for the washer. How to prevent it? First you have to inspect water fill hoses at least every three months. If they are rusted or you found bubbles on the hoses, they have to […]